Press "Enter" to skip to content

Tutorial: Tank Routine maintenance and Troubleshooting

Thanks for visiting MistHub’s Help guide Tank Maintenance and Troubleshooting. Here we will discuss how you can perform routine maintenance on the tank atomizers to keep them functioning in good shape. We’re going to also review some common problems as well as their solutions. First, let’s have a look at the way to properly work with a completely new tank or perhaps a new coil you simply positioned in your tank.


Whenever you install a new coil you will want to just be sure you prime it before deploying it. Priming a coil will make sure the wick inside is saturated with e-juice before its first use. This substantially lowers the potential for burning your wick or damaging your coil. To prime your coil you will want to place 4-5 drops of e-juice into the coil head. Install the coil head by threading it into the tank’s base. You may then fill and assemble your tank. For the best results you must wait 5-10 minutes before its first use. In case you are in a rush and cannot wait the 5-10 minutes you should at the very least wait 1-2 minutes, close the airflow and take several deep pulls without firing your device. You have to be in a position to then re-open the airflow and employ the tank normally without issue.

Whilst it may seem like a complex task to help keep your tank properly it is in reality very easy. First of all you will want to ensure that it stays clean. One or more times monthly clean your tank. Start with removing the coil(s) as well as any O-rings. While treatment of O-rings look for signs of wear or any cracks. When the any O-rings are damaged, replace them. Clean your tank thoroughly using isopropyl alcohol or domestic hot water along with a mild dish soap on both the inside and out. Make sure to pay special attention to the threads (a well used toothbrush can help for this part). Be sure you wash your O-rings too. Rinse it, then rinse it again simply to be certain there is absolutely no soap or residue forgotten. If your wotofo is totally dry you’re to reassemble and employ it again.
The most common issue tank users are faced with is leaks. A leaky tank can be a real inconvenience but typically these are relatively easy to fix. 99 percent of times a tank is leaking which is letting air in somewhere which breaks the vacuum that holds your e-liquid in the tank. First, go ahead and take tank apart inspecting all glass or plastic parts trying to find any cracks. Unless you see any, look at the O-rings for indications of damage or cracks. Or no of the aforementioned mentioned parts are damaged in any respect replace them when needed. Make sure you check and be sure the coil head is fully threaded into place but isn’t overly tight. It must be easily removable without using tools. Whether it is too tight it might have damaged the O-ring(s) on the bottom in the coil or pushed them misplaced. When the O-rings around the coil are damaged replace them or the entire coil. If your tank is constantly on the leak and all of the aforementioned continues to be checked additionally, it can be linked to a negative coil head. With time and through use the wicking materials can break down rather than hold as much juice because they once did. This makes a lack of surface tension allowing air to sneak in from the coil whereby it ought to be changed.
To get more information about smoktech explore our internet page: visit site