Carbide burs are one of the most in-demand and versatile cutting tools employed in practically every industry. Produced from Tungsten Carbide they may be primarily employed to remove burrs (the little flakes of metal) that often stick to the job piece after the machining process. Burs can be purchased in standard lengths long series (for difficult to reach applications) and in miniature sizes (to use in pencil grinders).
Features
Solid carbide tools offer long tool life and faster cutting speeds than other substrates, but you are more brittle and must be used with rigid tool holding systems
Uncoated tools feature only the base substrate with no additional treatment or coatings and they are ideal for an array of applications
Round shanks allow use with a wide range of tool holding systems
Double-cut style has rows of cutting teeth decline in two intersecting directions for fast material removal and a rougher finish
For deburring, interior contour work
CUT TYPE
Singlecut
General purpose tool for certain, copper, brass and steels
Fairly aggressive cutting action, with good material removal rates
It leaves a great finish of many all materials, but the bite could be demanding on operators
Doublecut
For general purpose use including surefire, copper, brass and steels
The Doublecut runs on the cross flute of exactly half the quantity of standard flutes within a opposing helix
Sliver sizing is reduced, as they are the operator fatigue in the balanced cutting forces
Lower RPMs may be utilized with little negative affect performance
The decreased load equates to operator’s often feeding it more aggressively
Alumacut
Great for all non-ferrous, non-metallic workpieces like aluminum, zinc, plastic, wood, etc.
An exceptionally aggressive cutting action, with little or no possibility of plugging these flutes up
Diamondcut
Can be a finer cut of opposing helixes
Operating control is very good for the reason that biting action is limited as is the silver size made out of it
This version is often preferred in shops where titanium along with other difficult materials (superalloys) are being deburred
With the teeth being smaller and more fragile therefore, tool life is not normally a a few import
Fiberglass tends to cut nicely with Diamondcut
Chipbreaker
Another sort of the Doublecut, it is a slightly less aggressive tool whose main purpose is always to simply interupt the cut
A single, opposing helix is ground within a spiral round the tool, typically
Silver size goes down, surface finish goes down marginally, hand control goes up, marginally
For more information about https://www.burrs4less.com/sa-9-31.html you can check our internet page
Be First to Comment